• If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below.


No announcement yet.

Joker Command

  • Filter
  • Time
  • Show
Clear All
new posts

  • Joker Command

    Can someone fill me in these questions? Say this is my joker command code:

    D00513DC XXXX
    If I add xxxx = 0000, does it means rather I press any button or not; the code is activated?
    Because when I use this method; eventhough I press any button, the code is activated. Which my thought would be if buttons are pressed then the code shouldn't activate.

    Is there a way we can do an IF statement into gameshark? For example:
    If Joker command = 1 to 80 then activate this codes?
    Last edited by asianking; 10-06-2015, 11:56 AM.

  • #2
    if used 0000 for normal joker code then code is on any time any button is NOT pressed
    if put 0001, then code only on when that button is pressed

    there is a less than and greater than condition too
    so put greater than 0001 and less than 0080